Milliradians to Points calculator

Milliradians

The PSO-1 reticle in a Dragunov sniper rifle has 10 horizontal lines with 1-mil spacing, which can be used to compensate for wind drift, impact correction or range estimation.

Source: Wikipedia

Points

32-point compass rose.

Source: Wikipedia

Milliradians to Points Conversion Table

Below you can generate and download as CSV, Excel, PDF or print the Milliradians to Points conversion table based on your needs.

Selected rounding: none (You can change it above in the dropdown)

• Point (11.25°)

  The points of the compass mark the divisions on a compass, which is primarily divided into four points: north, south, east, and west. These cardinal directions are further subdivided by the addition of the four intercardinal (or ordinal) directions—northeast (NE), southeast (SE), southwest (SW), and northwest (NW)—to indicate the eight principal winds. In meteorological usage, further intermediate points between cardinal and ordinal points, such as north-northeast (NNE) are added to give the 16 points of a compass rose. The European nautical tradition retained the term "one point" to describe 1⁄32 of a circle in such phrases as "two points to starboard". By the middle of the eighteenth century, the 32-point system was extended with half- and quarter-points to allow 128 directions to be differentiated.

• Milliradian (0.0563°)

  A milliradian, often called a mil or mrad, is an SI derived unit for angular measurement which is defined as a thousandth of a radian (0.001 radian). Mils are used in adjustment of firearm sights by adjusting the angle of the sight compared to the barrel (up, down, left or right). Mils are also used for comparing shot groupings, or to compare the difficulty of hitting different sized shooting targets at different distances. When using a scope with both mil adjustment and a reticle with mil markings (called a mil/mil scope), the shooter can use the reticle as a "ruler" to count the number of mils a shot was off target which directly translates to the sight adjustment needed to hit the target with a follow up shot. Optics with mil markings in the reticle can also be used to make a range estimation of a known size target, or vice versa to determine a target size if the distance is known, a practice called "milling".