Quadrants to Milliradians calculator

Quadrants

A quarter circle sector is equal to 90°.

Source: Wikipedia

Milliradians

The PSO-1 reticle in a Dragunov sniper rifle has 10 horizontal lines with 1-mil spacing, which can be used to compensate for wind drift, impact correction or range estimation.

Source: Wikipedia

Quadrants to Milliradians Conversion Table

Below you can generate and download as CSV, Excel, PDF or print the Quadrants to Milliradians conversion table based on your needs.

Selected rounding: none (You can change it above in the dropdown)

• Quadrant (90°)

  A circular sector or circle sector (symbol: ⌔), is the portion of a disk enclosed by two radii and an arc, where the smaller area is known as the minor sector and the larger being the major sector. In the diagram, θ is the central angle in radians, r the radius of the circle, and L is the arc length of the minor sector. A sector with the central angle of 180° is called a half-disk and is bounded by a diameter and a semicircle. Sectors with other central angles are sometimes given special names, these include quadrants (90°), sextants (60°) and octants (45°), which come from the sector being one 4th or 6th or 8th part of a full circle, respectively.

• Milliradian (0.0563°)

  A milliradian, often called a mil or mrad, is an SI derived unit for angular measurement which is defined as a thousandth of a radian (0.001 radian). Mils are used in adjustment of firearm sights by adjusting the angle of the sight compared to the barrel (up, down, left or right). Mils are also used for comparing shot groupings, or to compare the difficulty of hitting different sized shooting targets at different distances. When using a scope with both mil adjustment and a reticle with mil markings (called a mil/mil scope), the shooter can use the reticle as a "ruler" to count the number of mils a shot was off target which directly translates to the sight adjustment needed to hit the target with a follow up shot. Optics with mil markings in the reticle can also be used to make a range estimation of a known size target, or vice versa to determine a target size if the distance is known, a practice called "milling".